Build Package Suited For 2014+ Toyota 4Runner Non-KDSS

Vehicle Fitment

This Kit Includes:

• Stage 4 Foam Cell Pro Suspension Kit
• Front Coil Springs - (1pair)
• Rear Coil Springs - (1pair)
• 45682FEC - Rear Shock Absorber - Foam Cell Pro (2)
• 45710FE - Front Coil Over - Foam Cell Pro (2)
• UCA001FA - Pro Forge Upper Control Arms (1 pair)
• 1209K - Front Sway Bar Spacer Kit (one set)
• PANHARD015 - Rear Adjustable Panhard Bar (1)
• SBEXT006 - Rear Sway Bar Adjustable Endlinks (2) Not needed on KDSS vehicles.
• LTA003-4R - Rear Adjustable Lower Trailing Arm (2)
  
  
• If Rear Airbag Delete Kit is Needed:
• 1218ADK - Adjustable Rear Airbag Delete Kit
  
  
• Raid Steel Front Bumper
• Bolt-On installation with mounting hardware
• Bright Saber LED Single Row Light Bar - 20"
  
  
• Raid Steel Rear Bumper
• Bolt-On installation with mounting hardware
  
  
• Rear Bumper Lighting - 1st Pair (depending on selection can include one of the following):
• (2) 3.2" 40W Spot Beam LED Cube Lights - Clear
  
• (2) 3.2" 40W Flood Beam LED Cube Lights - Clear
• (2) 3.2" 40W Spot Beam LED Cube Lights - Amber
• (2) 3.2" 40W Flood Beam LED Cube Lights - Amber
  
  
• Rear Bumper Lighting - 2nd Pair (depending on selection can include one of the following):
• (2) 2.8" 20W Spot Beam LED Cube Lights - Clear
• (2) 2.8" 20W Flood Beam LED Cube Lights - Clear
• (2) 2.8" 20W Spot Beam LED Cube Lights - Amber
• (2) 2.8" 20W Flood Beam LED Cube Lights - Amber
• (2) 2.8" 20W Flood Beam LED Cube Lights - Red
  
  
• Raid Series Heavy Duty Side Steps
• Heavy Duty Skid Plate Kit

Installation

Suspension Kit Install Video:

Raid Series Front Bumper Install Video:

Winch Installation Notice:

We recommend that when installing any Ironman 4x4 Monster Winch to check that the length of bolt thread is sufficient to secure the winch to the mounting cradle.

Some mounting cradles may have a thicker or dual-skinned mounting plate which may render the supplied bolts too short once installed with a spring & flat washer. There must be 1-3 threads protruding beyond the nut when fully tightened. To ensure the winch is secured correctly.

If at least 1 thread is not protruding beyond the nut, it is recommended that a longer bolt is sourced from your local supplier to the following specifications:

• Hex Nut, M10 x 40mm x 1.5p Grade 8.8 or Higher

See the photo below for proper installation: